Those steps need to be paid attention to from hot drilling to finished product

Those steps need to be paid attention to from hot drilling to finished product
Hot diamond technology refers to the technology of setting diamonds on some materials such as leather and cloth to make the finished product more beautiful and beautiful. Hot drilling is divided into three steps:
1. Drill selection: It is the initial screening of the hot drills entering the workbench.
2. Arranging diamonds First, make templates of various patterns, then arrange the diamonds to a fixed position on the template, and then use adhesive paper to stick the arranged pictures to use as diamonds. For the processed heat map, it is necessary to check whether there are missing drills, reverse drills, and bad drills.
3. Hot drill Hot drill mainly uses several machines, they are: ultrasonic hot drill machine, ultrasonic point drill machine, ultrasonic nail drill machine, heat press machine and so on.
Check whether the picture is regular before ironing, if it is irregular, it will affect the appearance, please do not iron it hard. After ironing, check whether there is anything that cannot be ironed. If so, analyze the reason. If there is no rubber bottom, use a good drill to fill it up, and heat it with a soldering iron alone. If it is caused by insufficient temperature or pressure, the temperature and pressure should be adjusted appropriately.

In the process of hot drilling, the choice of diamonds is very important. Here are a few key points for choosing diamonds:

1. First look at the appearance
First of all, look at the cutting surface of the hot drill. The more cutting surfaces, the higher the refractive index and the better the brightness. Secondly, check whether the cutting surface is even. The hot-drilling process has strict requirements and complicated process, and the yield rate is not very high. Diamonds with a defective rate of 3%-5% should be regarded as good products, and then the size of the diamonds is consistent. The diameter of SS6 is 1.9-2.1mm, and the diameter of SS10 is 2.7-2.9mm**”. It should also be checked wheth.

2. Look at the gum
Turn the diamond over to see the color of the glue on the back, whether the color is uniform and not different in depth. The color is bright and even, and it is considered a good diamond.

3. Look firm
The higher the solubility of the glue on the back of the hot diamond, the better the firmness of the diamond. The best way to identify diamonds is: put them in the washing machine after ironing, if they do not fall off after washing, it proves that the fastness is good, and if they fall off after washing, it proves that the glue is not strong enough, and good products will not fall off after dry cleaning, which is also We mentioned earlier in this article the common small problems of hot-drilling.